Stand Alone keypad Access Control ACKP008

Non-waterproof
Strong Zinc Alloy Electroplated anti-vandal case
Full programming from the keypad
2000 users, supports Card, PIN, Card+PIN
Can be used as a stand-alone keypad
Backlight keys
Wiegand 26 input for connection to external reader
Wiegand 26 output for connection to a controller
Adjustable Door Output time, Alarm time, Door Open time
Very low power consumption (30mA)
Fast operating speed, <20ms with 2000 users
Lock output current short circuit protection
Easy to install and program
Built in light dependent resistor (LDR) for anti tamper
Built in buzzer
Red, Yellow and Green LEDs display the working status

Technical Specifications

Operating Voltage: 12VDC
User Capacity: 2000
Card Reading Distance: 3-6cm
Frequency: 125KHZ
Active Current: <60mA Idle Current: 25±5mA Lock Output Load: Max 3A Alarm Output Load: Max 20A Operating Temperature: -45~60C Operating Humidity: 10%~90% RH Waterproof: Conforms to IP68 Adjustable Door Relay Time: 0-99 seconds Adjustable Alarm Time: 0-3 minutes Wiegand Interface: Wiegand 26 bit Wiring Connections: Electric Lock, Exit Button, External Alarm Dimension (LxWxH): 109x76x26mm / 4.3x3x1.02in Net Weight: 440g

Application

Remove the back cover from the keypad using the supplied special screw driver
Drill 2 holes on the wall for the Self tapping screws and 1 hole for the cable
Put the supplied rubber bungs into the two holes
Fix the back cover firmly on the wall with 2 Self tapping screws
Thread the cable through the cable hole
Attach the keypad to the back cover